M. Springer
J. Düsing
J. Koch
P. Jäschke
S. Kaierle
L. Overmeyer

Laser-induced forward transfer as a potential alternative to pick-and-place technology when assembling semiconductor components

J. Laser Appl.
4
33
042030
2021
Type: Zeitschriftenaufsatz (reviewed)
Abstract
Fabrication technologies for the semiconductor industry have enabled ever smaller electronic components but now face a fundamental limit in their assembly. As the components get smaller and smaller, the difficulty of assembly increases. At the same time, the number of components per circuit board area is growing, as is the case with LED displays. This in turn calls for an increasing assembly rate. The conventional pick-and-place method can handle approximately 25–30 thousand dies per hour but has increasing limitations when component dimensions are reduced below 150 μm edge length. Laser-induced forward transfer is used as a potential alternative for an assembly of semiconductor components. This technique allows to transfer semiconductor components with an edge length of less than 150 μm to a target substrate. The current process is contactless, damage-free, and has sufficient placement accuracy. If this process is combined with the property of high-pulse repetition rates, it is possible to significantly increase the assembly rate of semiconductor components compared to the current limitations. The aim of this study is to characterize the flight properties of silicon semiconductor components of various dimensions in a laser-driven transfer process using optical imaging methods. This method allows to analyze velocity, the direction of fall, and acceleration of falling components. The results can be used to analyze the transfer behavior of various component sizes and to make estimates of the stability of the transfer process.